GB/T 9410-2008 in English

《GB/T 9410-2008移动通信天线通用技术规范》由339-1（工业和信息化部（电子））归口，主管部门为工业和信息化部（电子）。
本标准给出了移动通信天线的常用术语和定义，规定了它的技术要求、试验方法、检验规则以及标志、包装、运输和贮存要求。本标准适用于25MHz~6000MHz频段移动通信线极化无源天线。本标准是制定移动通信天线产品规范必须遵循的基本原则和最低要求。

1 Scope

This standard provides common terms and definitions and specifies technical requirements, test methods, inspection rules, marking, packaging, transportation and storage requirements for mobile communication antennas.

This standard is applicable to linearly polarized passive antennas for the frequency range of 25 MHz to 6 000 MHz.

This standard provides the basic principles and minimum requirements to which must be conformed for developing specifications for mobile communication antenna products.

2 Normative References

The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.

GB/T 191

Packaging—Pictorial Marking for Handling of Goods (GB/T 191-2000, eqv ISO 780:1997)
GB/T 2423.1-2001

Environmental Testing for Electric and Electronic Products—Part 2: Test Methods—Test A: Cold (idt IEC 60068-2-1:1990)
GB/T 2423.2-2001

Environmental Testing for Electric and Electronic Products—Part 2: Test Methods—Test B: Dry Heat (idt IEC 60068-2-2:1974)
GB/T 2423.3-1993


Basic Environmental Testing Procedures for Electric and Electronic Products—Test Ca: Damp Heat, Steady State (eqv IEC 60068-2-3:1984)
GB/T 2423.5-1995


Environmental Testing for Electric and Electronic Products—Part 2: Test Methods—Test Ea and Guidance: Shock (idt IEC 60068-2-27:1987)
GB/T 2423.6-1995


Environmental Testing for Electric and Electronic Products—Part 2: Test Methods—Test Eb and Guidance: Bump (idt IEC 60068-2-29:1987)
GB/T 2423.10-1995


Environmental Testing for Electric and Electronic Products—Part 2: Test Methods—Test Fc and Guidance: Vibration (Sinusoidal) (idt IEC 60068-2-6:1982)

Foreword i
1 Scope
2 Normative References
3 Terms and Definitions
4 Technical Requirements
4.1 General Structure Requirements
4.2 Technical Requirements for Electrical Property
4.3 Environmental Adaptation Requirements
5 Test Methods
5.1 Test Conditions
5.2 Inspection Method for General Structure Requirements
5.3 Electrical Property Measurement Method
5.4 Environmental Test Requirements and Methods
6 Inspection Rules
6.1 Appraisal Inspection
6.2 Quality Conformity Inspection
7 Marking, Packaging, Transportation and Storage
7.1 Marking
7.2 Packaging
7.3 Transportation
7.4 Storage
Annex A (Informative) Introduction of Antenna Test Field