QC/T 989-2014 in English

1 Scope

This standard specifies general requirements, safety requirements, mechanical strength, appearance and dimensions, environmental resistance requirements, assemble requirements, test methods, designation, marking, transportation, storage and packaging of traction battery enclosure for electric vehicles.
This standard is applicable to on-board charging battery enclosure and swapping battery enclosure.

2 Normative References

The following documents are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB 2894 Safety signs and guideline for the use
GB 4208-2008 Degrees of protection provided by enclosure (IP code)
GB/T 2408-2008 Plastics — Determination of burning characteristics — Horizontal and vertical test
GB/T 13306-2011 Plates
GB/T 18384.1 Electrically propelled road vehicles — Safety specifications — Part 1: On-board rechargeable energy storage system (REESS)
GB/T 18384.3-2001 Electric vehicles — Safety specification — Part 3: Protection of persons against electric hazards
GB/T 18455-2010 Package recycling marking
GB/T 19596 Terminology of electric vehicles
QC/T 238 Storage and preservation for automotive parts
QC/T 413-2002 Basic technical requirements for automotive electric equipment
QC/T 625-1999 Metallic coatings and conversion coatings for automobiles
QC/T 484 Automobile — Paint coating

3 Terms and Definitions

For the purpose of this document, terms and definitions given in GB/T 19596 and the following apply.

Foreword II
1 Scope
2 Normative References
3 Terms and Definitions
4 Requirements
5 Test Method
6 Nameplate and Marking
7 Transportation, Storage and Packaging Requirements
Appendix A (Informative) Schematic Diagram for Dimensions of Battery Enclosure Panel