GB/T 4199-2003 in English

《GB/T 4199-2003滚动轴承 公差 定义》由TC98（全国滚动轴承标准化技术委员会）归口，主管部门为中国机械工业联合会。
本标准规定了适用于滚动轴承的外形尺寸公差、形位公差、旋转精度及内部游隙的术语，并规定了这些公差所适用的一般条件及所定义的若干概念的符号。

1 Scope

This Standard defines terms specifying tolerances for boundary dimensions, geometrical accuracy, running accuracy and internal clearance for rolling bearings. In addition, it specifies general conditions under which these tolerances apply and gives symbols for a number of the concepts defined.
Measuring and inspection principles and methods for assessing compliance with many of the definitions in this Standard are given in GB/T 307.2-1995. GB/T 6930-2002 is a vocabulary of terms in the field of rolling bearings and, as such, is a valuable complement to this Standard.

2 Normative References

The following normative documents contain provisions which, through reference in this text, constitute provisions of this Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 1800.1-1997 Limits and Fits — Bases — Part 1: Terminology (neq ISO 286-1:1988)
GB/T 16892-1997 Geometrical Tolerancing Indication of Non-rigid Parts (eqv ISO 10579:1993)
ISO 1:1975 Standard Reference Temperature for Industrial Length Measurements.

3 General

Contents
Foreword I
1 Scope
2 Normative References
3 General
4 Axes, Directions, Planes, Positions and Surfaces
5 Boundary Dimensions
6 Geometrical Accuracy
7 Running Accuracy
8 Internal Clearance
Appendix A
Bibliography
Indexes