GB/T 5193-2007 in English

《GB/T 5193-2007钛及钛合金加工产品超声波探伤方法》由TC243（全国有色金属标准化技术委员会）归口，TC243SC4（全国有色金属标准化技术委员会粉末冶金分会）执行，主管部门为中国有色金属工业协会。
本标准规定了钛及钛合金加工产品超声波探伤的要求、探伤设备、对比试块、探伤、验收、检验记录和报告。

1 Scope

This standard specifies the requirements, inspection equipment, reference block, inspection, acceptance, inspection record and report of the ultrasonic inspection for wrought titanium and titanium alloy products.
This standard is applicable to the ultrasonic inspection for the wrought titanium and titanium alloy products with cross-section thickness larger than 6 mm~230 mm.

2 Normative References

The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this standard are encouraged to study whether the latest editions of these documents are applicable. For undated references, the latest edition of the normative documents referred to applies.
JB/T 10061 Commonly Used Specification for A-mode Ultrasonic Flaw Detector Using Pulse Echo Technique

Foreword I
1 Scope
2 Normative References
3 Requirements
4 Inspection Equipment
5 Reference Block
6 Inspection
7 Acceptance
8 Inspection Record and Report
Appendix A (Normative) Requirements for Reference Block