GB/T 6903-2022 in English
VALIDAnalysis of water used in boiler and cooling system—General rule
- Issued on:2022-03-09
- Implemented on:2022-10-01
- File Format:PDF
- Delivery:Via email within 1~3 business days
$156.00
《GB/T 6903-2022锅炉用水和冷却水分析方法 通则》由TC63（全国化学标准化技术委员会）归口，TC63SC5（全国化学标准化技术委员会水处理剂分会）执行，主管部门为中国石油和化学工业联合会。
Introduction
Analysis of the elements of the GB/T 6903-2024 standard framework upgrade
| Dimensions | 2005 Edition | 2022 Edition | Technical Improvements |
|---|---|---|---|
| Water Quality Type | Boiler Water | Boiler Water + Cooling Water | Extended Application Scenarios |
| Units of Measurement | Conventional Expressions | Fully Connected with the GB3100 International System of Units | International Data Comparison |
| Precision detection | Unclassified | Differentiate trace/constant analysis water requirements | Error rate reduced by 40% |
Terminology update and core indicator analysis
The new standard integrates the definition of cooling water from the HJ596 standard and distinguishes the application scenarios of the two subsystems of direct current and circulation. The standardized numerical expression adopts the GB/T8170 rounding standard, and clarifies the calculation formulas of the repeatability limit (r=2.83Sr) and the reproducibility limit (R=2.83SR).
Key points of laboratory standard innovation
- Mandatory testing device with closed flow cell, on-site pH testing error ≤0.03
- Level 3 water quality control: trace analysis uses high-purity water of >16MΩ·cm
- Data security requirements: Establish a complete traceability system from sampling to archiving
Analysis process optimization implementation guide
- Pretreatment inspection: physical properties must be recorded within 30 seconds after sampling
- Stability control: unstable indicators must be measured within 12 hours after sampling
- Dual reagent correction formula: A_{test}=A_{double}-A_{single} (relative error correction)
Example of problem solving
When the difference between two chemical oxygen demand measurements exceeds the allowable difference, the laboratory should: 1) re-prepare the standard solution 2) replace the glassware used for analysis 3) check the water bath temperature fluctuation value (≤±0.1℃)
Loading PDF document...
Error loading PDF. Please make sure the file is valid and try again.
