QC/T 660-2000 in English

1 Scope

This standard specifies the test method for compressor of automobile air conditioner

This standard is applicable to the compressor of automobile air conditioner using refrigerant HFC-134a, including compressor with constant displacement and compressor with variable displacement.

2 Normative References

The following standards contain provisions which, through reference in this standard, constitute provisions of this standard. At time of publication, the editions indicated are valid. All standards are subject to revision, and parties using the standard shall investigate the possibility of applying the latest edition of the standards indicated below.

GB/T 3785-1983 Electric, Sonic Properties and Measuring Methods for Sound Level Meters
GB/T 5773-1986 The Method of Performance Test for Positive Displacement Refrigerant Compressors
GB/T 6283-1986 Chemical Products — Determination of Water — Karl·Fischer Method (General Method)
GB/T 10125-1997 Corrosion Tests in Artificial Atmospheres — Salt Spray Tests
JB 4330-1986 Determination of Sound Power Level for Noise Emitted by Refrigerating and Air Conditioning Equipments — Engineering Method
JB/T 9058-1999 Measuring Method of Refrigerating Equipment Cleanliness

3 Test Requirements

3.1 Ambient temperature

Unless otherwise specified in the standard, generally, the test ambient temperature is 10℃~35℃.

3.2 Test refrigerant and lubricant

Coolant HFC-134a is adopted, and corresponding lubricant is adopted depending on the design specification.

3.3 Test refrigerant circulating system

3.3.1 Expel noncondensable gas in the system, and make sure refrigerant and lubricant are free from leakage.

3.3.2 Refrigerant and lubricant in the system shall be of proper amount and meet the relevant requirements.

3.4 Measuring instrument and accuracy

3.4.1 Test instruments shall be accompanied with quality certificates within the effective service life marked by metering or relevant departments.

3.4.2 Unless otherwise specified by the standard or relevant standards, test instruments shall meet the precision requirements in Table 1.

Foreword i
1 Scope
2 Normative References
3 Test Requirements
4 Test Methods
Annex A (Normative) Determination Method for Compressor Cleanliness