QC/T 751-2006 in English
SUPERSEDEDMethod of durability test for catalytic converter of motorcycle and moped
- Issued on:2006-03-07
- Implemented on:2006-08-01
- File Format:PDF
- Delivery:Via email within 1~3 business days
$127.00
Method of durability test for catalytic converter of motorcycle and moped
1 Scope
This standard specifies the test procedure, test method, test result analysis and report of durability test for catalytic converters of motorcycles and mopeds on road and engine bed.
This standard is applicable to catalytic converters of motorcycles and mopeds.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this specification. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
GB/T 4570-1995 Test method of durability for motorcycles and mopeds
GB/T 5363-1995 Method of bed test of gasoline engine for motorcycles and mopeds
GB/T 5378-1994 General rules of running test for motorcycles and mopeds
GB 14621 Limits and measurement methods for exhaust emissions from motorcycles and mopeds at idle speed
GB 14622 Limits and measurement methods for exhaust emissions from motorcycles under running mode
GB 17930-1999 Unleaded petrol (gasoline) for motor vehicles
GB 18176 Limits and measurement methods for exhaust emissions from mopeds under running mode
3 Terms and definitions
For the purposes of this standard, the following terms and definitions apply.
3.1
catalytic converter
catalytic device mounted in the motorcycle exhaust system, which can reduce the emissions of carbon monoxide (CO), hydrocarbons (HC) and nitrogen oxides (NOX) in the exhaust system through the reduction or oxidation reaction of catalyst
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Test procedure
5 Test method
6 Test result analysis and report
Annex A (Normative) Test record of exhaust emissions
Annex B (Normative) Bed rapid aging test cycle
Annex C (Normative) Decay curve of conversion ratio of catalytic converter

Loading PDF document...
Error loading PDF. Please make sure the file is valid and try again.
We also recommend
-

QCN 29024-1991 in English
Mopeds carburetor - Test method
- -

QC/T 685-2002 in English
General technical conditions for plunger type oil pump of motorcycles and mopeds
2002-12-31 -

QC/T 29117.17.1-1993 in English
Quality inspection of motorcycle and moped products - Quality evaluation method for engine magneto
1993-10-20