QJ 2037A-1998 in English

Safety specification for standing test on solid rocket motor

1 Scope

1.1 Subject content

This standard specifies the safety technology and other requirements to be complied with during the preparation phase, the test phase and the post-test handling phase of the standing test on solid rocket motor (hereinafter referred to as the motor test).

1.2 Application scope

This standard is applicable to the safety tech management for various solid motor tests.

2 Normative references

QJ 1118A-95 General requirements for the design, manufacturing and acceptance of test stands for solid rocket motor
QJ 1658A-95 Methods of air tight test for solid rocket motor
QJ 2472.1-93 General specification for lifting devices - Beam-type lifting devices
QJ 2472.2-93 General technical specifications for lifting device - Cord lifting device
QJ 2575-93 Code for selection, test and scrapping of wire ropes for lifting
QJ 2765-95 Safety specification for lifting of solid rocket motors
QJ 2904-97 Design specification for lifting appliance of solid propellant rocket motor

3 Definitions

There is no provision in this clause.

4 General requirements

4.1 Requirements for test station

4.1.1 The test station shall be equipped with lightning protection facilities, whose effective scope of protection shall be greater than the scope of protection required.

4.1.2 The power lines of the test station shall be rubber insulated cords or cables with copper core, and the electrical appliance shall be of explosion-proof type.

1 Scope
3 Definitions
4 General requirements
5 Detailed requirements