Spectral peaks and peak positions

Spectral peaks and peak positions, Total:84 items.

The international standard classification for "Spectral peaks and peak positions" includes: Chemical analysis .

The Chinese standard classification for "Spectral peaks and peak positions" includes: Semiconductor emitting device , Technical Management , Basic standards and general methods .

Military Standard of the People's Republic of China-General Armament Department

GJB 8873-2016 High peak power laser device terminology
GJB 8546-2015 High peak power, high energy laser parameter terminology
GJB 9245-2017 High Peak Power Laser Optics Terminology
GJB/J 3352-1998 Calibration procedures for pulsed laser peak power meters
GJB 690-1990 Physiological tolerance limit of pilot lungs to peak decompression

Professional Standard - Electron

SJ 453-1973 Methods of measurement for pulse peak of rectifying current of high-voltage rectifier tubes
SJ/T 2658.12-2015 Measuring method for semiconductor infrared-emitting diode. Part 12: Peak-emission wavelength and spectral radiant bandwidth
SJ 2658.12-1986 Methods of Measurement for Semiconductor Infrared Diodes - Methods of Measurement for Peak Emission Wavelength and Spectral Half Width
SJ 454-1973 Methods of measurement for peak voltage drop of tube, reverse peak voltage drop of tube and rectifying current of high-voltage rectifier tubes
SJ 2355.7-1983 Method of measurement for peak emission wavelength and spectral radiation bandwidth of light-emitting devices

General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China

GB/T 41073-2021 Surface chemical analysis―Electron spectroscopies―Minimum reporting requirements for peak fitting in X-ray photoelectron spectroscopy

American National Standards Institute （ANSI)

ANSI/TIA-492CAAB-2000 Detail Specification for Class IVa Dispersion Unshifted Single-Mode Optical Fibers with Low Water Peak
ANSI/EIA/TIA 455-24:1991 Water Peak Attenuation Measurement of Single-Mode Fibers
ANSI/TIA/EIA-492CAAB-2000(2005) Detail Specification for Class IVa Dispersion-Unshifted Single-Mode Optical Fibers with Low Water Peak
ANSI/ASHRAE/ACCA 183-2007(R2020) Peak Cooling and Heating Load Calculations in Buildings Except Low-Rise Residential Buildings

American Society for Testing and Materials (ASTM)

ASTM E827-07 Standard Practice for Identifying Elements by the Peaks in Auger Electron Spectroscopy
ASTM E827-95 Standard Practice for Indentifying Elements by the Peaks in Auger Electron Spectroscopy
ASTM E827-02 Standard Practice for Indentifying Elements by the Peaks in Auger Electron Spectroscopy
ASTM D5788-95(2011) Standard Guide for Spiking Organics into Aqueous Samples
ASTM D5788-95 Standard Guide for Spiking Organics into Aqueous Samples
ASTM D5788-95(2001) Standard Guide for Spiking Organics into Aqueous Samples
ASTM C1871-22 Standard Test Method for Determination of Uranium Isotopic Composition by the Double Spike Method Using a Thermal Ionization Mass Spectrometer
ASTM C1871-18 Standard Test Method for Determination of Uranium Isotopic Composition by the Double Spike Method Using a Thermal Ionization Mass Spectrometer
ASTM C1871-18a Standard Test Method for Determination of Uranium Isotopic Composition by the Double Spike Method Using a Thermal Ionization Mass Spectrometer

Magyar Szabványügyi Testület

MSZ 20083-1967 Peak value of mechanical measuring instruments
MNOSZ 14376-1953 Peak performance of metalworking machine tools
MNOSZ 5535-1956 Microscope Preparation Healing Spring Table/Peak Position

American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE)

ASHRAE SE-99-1-2-1999 Effect of Beam Solar Radiation Distribution on Peak Cooling Loads
ASHRAE BN-97-4-1997 Symposium on Advanced Methods for Calculating Peak Cooling Loads
ASHRAE TO-98-20-2-1998 Monitored Summer Peak Attic Air Temperatures in Florida Residences
ASHRAE 3673-1993 Laboratory Testing of Control Strategies to Reduce Peak Air- Conditioning Loads

International Organization for Standardization (ISO)

ISO 6863:2024 Nuclear fuel technology — Preparation of spikes for isotope dilution mass spectrometry (IDMS)
ISO/CD 6863 Preparation of Plutonium and Uranium spikes for Isotope Dilution Mass Spectrometry (IDMS)
ISO 20903:2019 Surface chemical analysis — Auger electron spectroscopy and X-ray photoelectron spectroscopy — Methods used to determine peak intensities and information required when reporting results
ISO 20903:2011 Surface chemical analysis - Auger electron spectroscopy and X-ray photoelectron spectroscopy - Methods used to determine peak intensities and information required when reporting results
ISO 19830:2015 Surface chemical analysis - Electron spectroscopies - Minimum reporting requirements for peak fitting in X-ray photoelectron spectroscopy

International Telecommunication Union (ITU)

ITU-R BS.1771-2012 Requirements for loudness and true-peak indicating meters
ITU-R BS.1771-2006 Requirements for loudness and true-peak indicating meters
ITU-R BS.1771 FRENCH-2006 Requirements for loudness and true-peak indicating meters
ITU-R BS.1771-1-2012 Requirements for loudness and true-peak indicating meters
ITU-R BS.1771 SPANISH-2006 Requirements for loudness and true-peak indicating meters
ITU-R S.732-1992 Method for Statistical Processing of Earth-Station Antenna Side-Lobe Peaks - Section 4C - Earth Station and Baseband Characteristics - Earth Station Antennas - Maintenance of Earth Stations
ITU-R BS.1770-4-2015 Algorithms to measure audio programme loudness and true-peak audio level
ITU-R BS.1770-2-2011 Algorithms to measure audio programme loudness and true-peak audio level

Association for Electrical, Electronic & Information Technologies (VDE)

FNN SPITZENKAPPUNG-2017 Spitzenkappung - Ein neuer planerischer Freiheitsgrad - Moeglichkeiten zur Beruecksichtigung der Spitzenkappung bei der Netzplanung in Verteilnetzen

British Standards Institution (BSI)

24/30454135 DC BS ISO 6863 Nuclear fuel technology - Preparation of spikes for isotope dilution mass spectrometry (IDMS)
CP 1018-1971 Electric floorwarming systems for use with off-peak and similar supplies of electricity
BS ISO 19830:2015 Surface chemical analysis. Electron spectroscopies. Minimum reporting requirements for peak fitting in X-ray photoelectron spectroscopy
BS ISO 20903:2019 Surface chemical analysis. Auger electron spectroscopy and X-ray photoelectron spectroscopy. Methods used to determine peak intensities and information required when reporting results
BS ISO 20903:2006 Surface chemical analysis. Auger electron spectroscopy and X-ray photoelectron spectroscopy. Methods used to determine peak intensities and information required when reporting results
BS 6647:1985 Guide to oscilloscopes and peak voltmeters for impulse tests
BS 2606:1955 Specification for X-ray protective gloves for medical diagnostic purposes up to 150 kV peak
13/30275599 DC BS EN 10049. Measurement of roughness average Ra and peak count RPc on metallic flat products

American Gear Manufacturers Association

09FTM06-2009 Dependency of the Peak-to-Peak-Transmission-Error on the Type of Profile Correction and the Transverse Contact Ratio of the Gear Pair
P149.03-1983 Prediction of the Peak Temperature on the Surface of Thermoplastic Gear Teeth

European Committee for Electrotechnical Standardization（CENELEC）

HD 479-1986 Oscilloscopes and Peak Voltmeters for Impulse Tests

Gosstandart of Russia

GOST R 50005-1992 Lasers and solid-state laser heads. Measurement methods of peak local energy (power) density

Ente Nazionale Italiano di Unificazione

UNI EN 10049:2014 Measurement of roughness average Ra and peak count RPc on metallic flat products

(U.S.) Telecommunications Industries Association

TIA/EIA-492CAAB-2000 Detail Specification for Class IVa Dispersion-Unshifted Single-Mode Optical Fibers with Low Water Peak
EIA/TIA-455-24-1991 FOTP-24 Water Peak Attenuation Measurement of Single-Mode Fibers
TIA/EIA-455-24-1991 FOTP-24 Water Peak Attenuation Measurement of Single-Mode Fibers

Korean Agency for Technology and Standards (KATS)

KS C 2375-2006 Analytical method of polychlorinated biphenyls(PCBs)by gas chromatography peak pattern comparison
KS C 2375-2006(2016) Analytical method of polychlorinated biphenyls(PCBs)by gas chromatography peak pattern comparison
KS C 2375-2021 Analytical method of polychlorinated biphenyls(PCBs)by gas chromatography peak pattern comparison

American Water Works Association (AWWA)

AWWA ACE56139 Implementation of Finished Water Storage for Multi-Day Averaging of Peak Demands
AWWA ACE65613 Air or Particles — What Are the Turbidity Spikes in My Membrane Effluent

Society of Automotive Engineers (SAE)

SAE J911_198606 Surface Roughness and Peak Count Measurement of Cold-Rolled Sheet Steel
SAE J911_199803 Surface Roughness and Peak Count Measurement of Cold-Rolled Sheet Steel
SAE J911_196501 Surface Texture Measurement of Cold Rolled Sheet Steel
SAE J911_198110 Surface Roughness and Peak Count Measurement of Cold-Rolled Sheet Steel

Institute of Electrical and Electronics Engineers (IEEE)

IEEE 391-1976 STANDARD FOR HIGH-POWER (GREATER THAN 300 WATTS@ PEAK) PULSE TRANSFORMERS

German Institute for Standardization

DIN V 3141:1960 Representation of surface symbols on drawings and division of peak to valley heights
DIN 6809-5:1996 Clinical dosimetry - Part 5: Application of X-rays with peak voltages between 100 and 400 kV in radiotherapy
DIN EN 10049 E:2013 Draft Document - Measurement of roughness average Ra and peak count RPc on metallic flat products; German version FprEN 10049:2013

Indonesia Standards

SNI 04-6628-2001 Oscilloscopes and peak voltmeter for impulse tests

Kingdom of Bahrain Testing and Metrology Directorate

BH GSO ISO 19830:2017 Surface chemical analysis -- Electron spectroscopies -- Minimum reporting requirements for peak fitting in X-ray photoelectron spectroscopy

European Committee for Standardization (CEN)

EN 10049:2013 Measurement of roughness average Ra and peak count RPc on metallic flat products
EN 10049:2005 Measurement of roughness average Ra and peak count RPc on metallic flat products

Lithuanian Standards Office

LST EN 10049-2006 Measurement of roughness average Ra and peak count RPc on metallic flat products

Australian/New Zealand Standard (AU-AS/NZS)

AS/NZS 2512.8:1998 Methods of testing protective helmets Method 8: Measurement of peak deflection

Bureau of Indian Standards

IS 11349-1985 Specification for oscilloscopes and peak voltmeters for pulse testing

Danish Standards Foundation

DS/EN 10049:2006 Measurement of roughness average Ra and peak count RPc on metallic flat products

GCC Standardization Organization

GSO ISO 19830:2016 Surface chemical analysis -- Electron spectroscopies -- Minimum reporting requirements for peak fitting in X-ray photoelectron spectroscopy

Belgian Standards Institute

NBN E 52-019-1989 elevator. Calculation of the number and characteristics of elevators in capacity "peaks"

Others: Spectral peaks and peak positions