GB/T 14480.3-2020 in English
VALIDNon-destructive testing instruments—Equipment for eddy current examination—Part 3:System characteristics and verification
- Issued on:2020-12-14
- Implemented on:2021-07-01
- File Format:PDF
- Delivery:Via email within 1~3 business days
$97.00
《GB/T 14480.3-2020无损检测仪器 涡流检测设备 第3部分：系统性能和检验》由TC122（全国试验机标准化技术委员会）归口，TC122SC1（全国试验机标准化技术委员会无损检测仪器分会）执行，主管部门为中国机械工业联合会。
Introduction
Analysis of the core content of the standard
This standard is equivalent to the ISO 15548-3:2008 international standard, which specifies the test methods and inspection procedures for the system performance of eddy current testing equipment. The main technical updates include:
- New "General" clauses to clarify the basic principles of inspection
- Optimize the inspection level division (Level 1 functional inspection/Level 2 item-by-item verification/Level 3 performance verification)
- Detailed functional inspection implementation requirements
Key indicators of system performance
| Performance category | Detection elements | Typical parameters |
|---|---|---|
| Physical properties | Mechanical device configuration | Scanning speed ≥ 2m/min |
| Calibration performance | Reference test block response | Signal-to-noise ratio ≥ 20dB |
| Functional characteristics | Dynamic range | Phase accuracy±1° |
Key points for implementation of inspection grading
Case:An aviation company adopts a three-level inspection system:
- Level 1 rapid verification is performed using standard test blocks before starting work every day
- Special checks on Level 2 cable impedance, probe sensitivity, etc. are performed every quarter
- When accepting new equipment, the metrology agency is commissioned to carry out Level 3 full performance testing
Technology evolution analysis
Compared with the 2008 version of the standard, the 2020 version mainly strengthens:
- Software performance evaluation requirements for digital detection systems
- Synchronicity test method for multi-probe array system
- Stability control in dynamic detection scenarios
Implementation suggestions
Enterprises should establish:
- Inspection cycle management system based on risk analysis
- Special verification process for auxiliary equipment such as magnetic saturation device
- Traceability processing mechanism for out-of-limit data
Loading PDF document...
Error loading PDF. Please make sure the file is valid and try again.
We also recommend
-
GB/T 26838-2024 in English
Non-destructive testing instruments—Portable industrial X-ray radiographic equipment
2024-08-23 -
GB/Z 41285.1-2022 in English
Non-destructive testing instruments—Radiation protection rules for the technical application of sealed radioactive sources—Part 1:Stationary and mobile handling for γ radiography
2022-03-09 -
GB/T 23413-2009 in English
Determination of crystallite size and micro - strain of nano - Materials - X - ray diffraction line broadening method
2009-04-01 -
GB/T 32195-2015 in English
Non-destructive testing instruments―Quality inspection provisions
2015-12-10 -
GB/T 33885-2017 in English
Non-destructive testing instruments--General requirements for sampling, routine inspection and type inspection
2017-07-12 -
GB/T 36015-2018 in English
Non-destructive testing instruments—Performance and testintg rules of industrial digital X-ray imaging system
2018-03-15
