GB/T 26703-2011 in English

《GB/T 26703-2011皮鞋跟面耐磨性能试验方法 旋转辊筒式磨耗机法》由TC305（全国制鞋标准化技术委员会）归口，主管部门为中国轻工业联合会。

ChinaStandards.net is in charge of this English translation. In case of any doubt about the contents of English translation, the Chinese original shall be considered authoritative.

This Standard was drafted according to the rules given in "Directives for standardization - Part 1: Structure and Drafting of Standards" (GB/T 1.1-2009).

Attention is drawn to the possibility that some of the elements of this standard may be the subject of patent rights. The issuing body of this document shall not be held responsible for identifying any or all such patent rights.
This standard was proposed by China National Light Industry Council.

This standard is under the jurisdiction of National Technical Committee on Shoes of Standardization Administration Leather Shoes Technical Subcommittee (SAC/TC 305/SC 1).


Determination of Abrasion Resistance for Top Piece of Leather Shoes - Rotation Cylindrical Drum Method

1 Scope

This standard specifies the test method for determination of abrasion resistance for top piece of leather shoes by rotation cylindrical drum method.

This standard is applicable to top piece of leather shoes of various materials.

2 Normative References

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

GB/T 533 – 2008 Rubber Vulcanized or Thermoplastic - Determination of Density
GB/T 9867 – 2008 Rubber Vulcanized or Thermoplastic - Determination of Abrasion Resistance Using a Rotating Cylindrical Drum Device

3 Apparatus and Materials

3.1 Abrasion machine

Abrasion machine shall meet the requirements of 5.1 in GB/T 9867 - 2008 and adopt non-rotating holder.

3.2 Abrasive cloth

Abrasive cloth shall meet the requirements of 5.2 in GB/T 9867-2008.

3.3 Balance

The balance used for weighing the mass of sample shall be accurate to 1mg.

3.4 Standard glue

Standard glue shall meet the requirements of B.2 in GB/T 9867 - 2008.

3.5 Rotating cutter

The size of rotating cutter shall meet the requirements of 5.3 in GB/T 9867 - 2008.

3.6 Abrasion machine for top piece of leather shoes

The grinding machine for top piece of leather shoes is as shown in Figure 1, which is used to cut the top piece of leather shoes into cylindrical sample. One side of the grinding machine is a grinding wheel (100 mm ~120 mm in diameter) driven by motor. The grinding wheel is white corundum, with the particle size of 60 meshes and linear speed of 15 m/s ~ 20 m/s. The other side is the holding device for top piece. Top piece sample is fixed in the holding device and can rotate with the motor of the holding device at the speed of 50 r/min~60 r/min. The distance between the grinding wheel and the holding device is adjustable, when the top piece sample gets close to the grinding wheel while rotating, the top piece will be ground by grinding wheel until it becomes a cylindrical sample with diameter of 16mm.

Foreword i
1 Scope
2 Normative References
3 Apparatus and Materials
4 Sample
5 Test Procedure
6 Test Result
7 Test Report
Bibliography