GB/T 4169.7-2006 in English
VALIDComponents of injection moulds for plastics - Part 7: Ejector plate
- Issued on:2006-12-08
- Implemented on:2007-04-01
- File Format:PDF
- Delivery:Via email within 1~3 business days
$97.00
《GB/T 4169.7-2006塑料注射模零件 第7部分：推板》由TC33（全国模具标准化技术委员会）归口，主管部门为国家标准化管理委员会。
本部分规定了塑料注射模用推板的尺寸规格和公差。本部分适用与塑料注射模所用的推板。本部分还给出了材料指南和硬度要求，并规定了推板的标记。
Scope
This part specifies the dimensional specifications and tolerances of push plates for plastic injection molds. This section applies to push plates and push rod fixing plates used in plastic injection molds. This part also gives material guidelines and hardness requirements, and specifies the marking of push plates.
Loading PDF document...
Error loading PDF. Please make sure the file is valid and try again.
We also recommend
-
GB/T 14663-2024 in English
Plastic package moulds—Technical specifications
2024-09-29 -
GB/T 20914.1-2007 in English
Stamping dies—Gas springs—Part 1:General specification
2007-03-12 -
GB/T 8844-2017 in English
Diecasting dies--Specifications
2017-09-29 -
GB/T 43234-2023 in English
Tools for moulding—Angle pins
2023-11-27 -
GB/T 4678.20-2025 in English
Die casting dies—components—Part 20: Hoisting columns
2025-05-30 -
GB/T 23562.1-2009 in English
Steel-plate die holders of stamping dies—Part 1:Rear-pillar die holders
2009-04-02 -
GB/T 4678.1-2017 in English
Diecasting dies--Components--Part 1: Die plates
2017-09-29 -
GB/T 2852-2008 in English
Ball-bearing die sets for stamping dies
2008-04-10
