GB/T 35097-2018 in English
VALIDMicrobeam analysis—Scanning electron microscopy with energy dispersive X-ray spectrosmetry—Determination of numberical concentration of inorganic fibrous particles in ambient air
- Issued on:2018-05-14
- Implemented on:2019-04-01
- File Format:PDF
- Delivery:Via email within 5 business days
$359.00
《GB/T 35097-2018微束分析 扫描电镜-能谱法 环境空气中石棉等无机纤维状颗粒计数浓度的测定》由TC38(全国微束分析标准化技术委员会)归口,主管部门为国家标准化管理委员会。
Scope
This standard specifies the method for measuring the count concentration of asbestos and other inorganic fibrous particles in ambient air by scanning electron microscope. This method also utilizes energy-dispersive X-ray analysis (EDX) to analyze the elemental composition of fibrous particles, and uses this data to distinguish asbestos fibers, calcium sulfate fibers, and other inorganic fibers. This standard applies to the determination of the count concentration of asbestos and other inorganic fibrous particles in the ambient air, and also applies to the detection of the count concentration of asbestos and other inorganic fibrous particles in the air in buildings. For example, after the removal and replacement of asbestos-containing building materials, the concentration of residual asbestos fibrous particles in the air is determined. If no fiber is found during the test (the number of fibers is 0), the upper limit of the 95% confidence interval is 2.99. If 1.0 m3 air passes through the sample membrane per square centimeter, and the area of 1.0 mm2 on the membrane is analyzed by scanning electron microscope, that is, the volume of air passing through the analyzed area membrane is 0.010 m3 , the detection limit is about 300/m3 fibers. The detection range of the concentration of fibrous particles on the membrane sample is about 3 particles/cm2~200 particles/cm2. Concentration values in air (fibers/m3) depend on the sample volume and can be calculated.

Loading PDF document...
Error loading PDF. Please make sure the file is valid and try again.
We also recommend
-

GB/T 25187-2024 in English
Surface chemical analysis—Auger electron spectroscopy—Description of selected instrumental performance parameters
2024-11-28 -

GB/T 15244-2013 in English
Microbeam analysis—Quantitative analysis of silicate glass by wavelength dispersive X-ray spectrometry and energy dispersive X-ray spectrometry
2013-07-19 -

GB/T 22461.3-2026 in English
Surface chemical analysis—Vocabulary—Part 3: Terms used in optical interface analysis
2026-01-28 -

GB/Z 122-2025 in English
Surface chemical analysis—Glow discharge mass spectrometry—Operating procedures
2025-12-03 -

GB/T 22461.2-2023 in English
Surface chemical analysis—Vocabulary—Part 2:Terms used in scanning probe microscopy
2023-05-23 -

GB/T 6284-2006 in English
Chemical products for industrial use - General method for determination of water content - The loss of mass on drying method
2006-12-29 -

GB/T 25184-2010 in English
Verification method for X-ray photoelectron spectrometers
2010-09-26 -

GB/T 18295-2026 in English
Microbeam analysis—Analysis method of sandstone sample of petroleum and gas reservoir by scanning electron microscope
2026-02-27 -

GB/T 26489-2011 in English
Methods for measuring super amphiphilicity of nanomaterials
2011-05-12 -

GB/T 22571-2017 in English
Surface chemical analysis--X-ray photoelectron spectrometers--Calibration of energy scales
2017-09-07